The installation and use of the speed reducer are directly related to the operating effect of the speed reducer, and should comply with the technical specifications and standards. Reducer test run time should not be less than two hours. The standard of normal operation is smooth running, no vibration, no noise, no leakage, no impact. If there is any abnormal situation, it should be timely. When the reducer drive coupling should be installed with protective devices, such as protrusions on the coupling or gears and sprockets. If the radial load on the output bearing is large, the reinforced type should also be selected. Before operation, the reducer should be prepared for operation. Remove the vent hole screw plug of the oil pool, replace it with a vent plug, open the screw of the oil level plug to check the height of the oil pipe, add lubricant over the oil level plug until the hole overflows, and then screw on the oil level plug to make sure that there is no error, and then start the test run. There are many optional types of couplings available for the speed reducer, but do not use a rigid fixed coupling because this type of coupling is difficult to install. If it is not installed properly, the load will increase, which can easily lead to bearing damage or even output shaft breakage. When installing the reducer, special attention should be paid to the drive shaft in the middle, the error in the middle should not exceed the amount of compensation for the coupling of the reducer, the reducer according to the requirements for the middle, you can get a good transmission effect and a longer service life. Reducer Fixed reducer is very important. In order to ensure stability and firmness, generally speaking, we should install the reducer on a horizontal foundation or base, at the same time, the oil in the oil drain tank should be able to discharge, cooling air should be able to circulate smoothly. Worm gear reducers that are not secured and have an unreliable foundation will cause vibration and also damage to the bearings and gears. Reducers are a common power transmission mechanism used in a variety of mechanical drive systems.

E-mail :
106549183@qq.com

Tel：
+86 15166666358

Address：
No.88 Keyun Road, Chengyang District, Qingdao, Shandong Province, China